Deutz 1012 Specifikace stáhnout pdf (Strana 222)

Page 2

Section 4.8

Service Training

4.8.1 MAST REMOVAL

- Remove the forks.

- Lower the fork carriage.

- Tilt the mast fully forward.

- Disconnect the hoses (6) on the fitting (7).

- Unscrew the overhead guard bearings on the left and right and slide the overhead guard back.

- Remove the left and right tilt cylinder pivots, tilt the cylinder up and secure it.

- Attach a rope to the top cross member of the outer upright and hook on a crane. Be sure that the load

capacity of the crane and rope is sufficient.

- Remove the mast pivot bearing pillows and lift the mast out of the pivots.

- Installation is the reverse of removal.

- Bleed the lift cylinders when taking the truck into operation again.

7 Fitting

8 Fork carriage

9 Cylinder mount

10 Washers

11 Washer

1 Retaining ring

2 Inner upright

3 Outer upright

4 Bracket

5 Lift cylinder

6 Hoses

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 281 282

Žádné komentáře

Deutz 1012 Specifikace Strana 222