Deutz 1012 Specifikace stáhnout pdf (Strana 49)

100

101

Service Training

Page 41

Section 4.1

09.06

- Turn bolts in again by 60° and gradually tighten to a

tightening torque of 7 Nm, 10 Nm and 30 Nm.

NOTE: Start with the outer boit remotest from

flywheel.

- Turn knurled lock bolt back again.

Remove press on device 100 830.

NOTE: Check smooth movement of control rod from

stop position to start position. Actuate cut-off

lever to this end.

- Mount new O-ring.

NOTE: Slightly oil O-ring.

- Press control rod into stop position using the cut-off

lever and retain.

- Install engine shut-off device. Tighten bolts. Plug in

cable connector.

Specified tightening torque: 21 Nm

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 281 282

Service Training 1
353 804 2401.0906 282

Komentáře k této Příručce

Žádné komentáře

Deutz 1012 Specifikace Strana 49

Komentáře k této Příručce

Související produkty a manuály pro Motor Deutz 1012