Deutz 1012 Specifikace stáhnout pdf (Strana 30)

100

101

Page 22

Section 4.1

Service Training

09.06

4.1.2.3 REPLACEMENT OF V-RIPPED BELT

Fit the V-ripped belt and tension it.

Pressh the belt tensioner pulley (1) in direction of the

arrow. Fit the V-ripped belt, and finally place it on pulley

(2). Loosen the belt tensioner pulley in opposite direction

to the arrow until the V-ripped belt is tensioned.

If the V-ripped belt is used again, make sure to observe

the wear limit.

Measure the distance "a" between the lug of the movable

tensioning arm and the stop of the fixed tensioner housing.

If the distance "a" is less than 3 mm, the V-ripped belt must

be replaced.

The V-ripped belt is equipped with a spring-loaded belt

tensioner pulley that tensions automatically, and it is not

re-tightened.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 281 282

Service Training 1
353 804 2401.0906 282

Komentáře k této Příručce

Žádné komentáře

Deutz 1012 Specifikace Strana 30

Komentáře k této Příručce

Související produkty a manuály pro Motor Deutz 1012